登录

  • 登录
  • 忘记密码?点击找回

注册

  • 获取手机验证码 60
  • 注册

找回密码

  • 获取手机验证码60
  • 找回
毕业论文网 > 毕业论文 > 土木建筑类 > 给排水科学与工程 > 正文

宿迁市工业园区奇隆公司2000吨酒精污水处理工程设计毕业论文

 2022-04-11 08:04  

论文总字数:22380字

摘 要

本次毕业设计要求根据相关资料设计一座酒精污水处理站,设计处理规模为2000m3/d。本设计采用预处理 厌氧 好氧的方式处理酒精废水。针对大颗粒悬浮物固体杂质采用格栅拦截后进入调节沉淀池进行预处理,酒精废水中的大量悬浮固体物质在沉淀池中迅速的沉淀下来。主体工艺是二级UASB与CASS工艺,污水经过两级UASB的厌氧处理,形成沉淀性能好的污泥,提高了反应器中的生物量,污水中的的大量有机物被去除。接下来的CASS工艺处理,微生物与污水充分混合得到充足的氧气,进一步增大了整个工艺的的氧化处理效率,最大限度的降低了处理后出水水质的COD、BOD值,提高了出水水质的质量。以厌氧好氧为主体,加上预处理,能够很好的降低酒精污水的有机物,但酒精废水处理真正能做到出水达标、废水治理的投资和运行费用都很省、废水回收效益高任然是一个任重而道远的课题。

关键词: 酒精污水 厌氧好氧 UASB CASS

ABSTRACT

The graduation project requires to design a alcohol sewage treatment plant according to the relevant documentation.The design treatment capacity of the plant is 2000m3 / d. The design treats alcohol wastewater by the process of pretreatment , anaerobic and aerobic treatment. A quantity of suspended solid particles are pretreated with regulating sedimentation tank, then most suspended solid particles settle down quickly in the sedimentation tank. The main process is the second grade UASB and CASS. Sewage is treated in anaerobism by the second grade UASB. Then, the sludge with good precipitation performance forms, which improve biomass of the reactor, A large amount of organic matter is removed. The next process is CASS, mixing microbes and wastewater to obtain sufficient oxygen, further increasing the efficiency of the whole process of oxidation, the quality of COD, BOD the effluent is reduced as much as possible. The main process is anaerobic and aerobic treatment, with pre-treatment, organics of the alcohol wastewater is removed. However, it's hard to make the quality of the effluent reach to standard, to save the cost of investment and operation, to improve the benefit of recovery of the wastewater. Treatment of sewage alcohol is still a long way.

目 录

摘 要 I

ABSTRACT II

第一章 绪论 1

1.1工程概况 1

1.2方案比选 2

1.2.1 预处理阶段 2

1.2.2 厌氧阶段 2

1.2.3 好氧阶段 3

1.3工艺流程 4

1.4进出水水质要求 4

第二章 污水处理 7

2.1.进水渠 7

2.2 中格栅 7

2.2.1 设计参数 8

2.2.2 格栅的设计与计算 8

2.3调节池 9

2.3.1 尺寸设计 9

2.3.2 潜水搅拌机选型 9

2.4提升泵 10

2.5沉淀池 10

2.6 集水池 12

2.6.1 提升泵选型 12

2.6.2 尺寸设计 13

2.7 一级UASB 13

2.7.1 反应区 13

2.7.2 三相分离器 14

2.7.3 进水系统设计  17

2.7.4 排水系统设计   18

2.7.4 排泥系统设计   19

2.7.5 产气设计  20

2.8 二级UASB 20

2.8.1 反应区 20

2.8.2 三相分离器 22

2.8.3 进水系统设计  24

2.8.5 排泥系统设计   26

2.8.6 产气设计  27

2.9 CASS 27

2.9.1 尺寸设计 27

2.9.2 鼓风设计 29

2.9.3 空气管路系统计算 31

2.9.4 排水系统计算 32

2.9.5 污泥系统计算 33

2.10 储气柜 34

2.10.1 尺寸设计 34

2.10.2 水封设计 35

第三章 污泥处理 37

3.1贮泥池 37

3.1.1 初沉污泥贮泥池 37

3.1.2 剩余污泥贮泥池 38

3.1污泥浓缩脱水处理 38

3.1.1 初沉污泥脱水 38

3.1.2 剩余污泥浓缩脱水 40

第四章 高程设计 45

4.1水损计算 45

4.2高程确定 46

第五章 污水厂投资估算 49

5.1直接费用 49

5.1.1 设备费用 49

5.1.2 土建费用 50

5.1.3 其他费用 51

5.2间接费用 51

5.3税金 51

5.4总投资 51

参考文献 54

第一章 绪论

1.1工程概况

酒精工业的污染以水的污染最为严重,生产过程中的废水主要来自蒸馏发酵成熟醪排出的酒精糟,生产设备的洗涤水、冲洗水,以及蒸煮、糖化、发酵、蒸馏工艺的冷却水等[2]。酒精废水是高浓度、高温度、高悬浮物的有机废水。

宿迁市奇隆公司的食用酒精制造产品原料为薯干类,采用发酵法生产酒精,生产过程产生大量的废液—槽液,废糟浓含有大量的有机物,废液浑浊,呈微酸性。该厂每日产生酒稿废槽液等废水1500m3,要求污水站处理规模2000m3/d。拟建厂区为图1中红框内,污水地面高度黄海高程36.40m,污水排放到厂区污水池,池底部标高-2.50m,园区污水厂管网管底标高为-1.80m.污水从原污水池提升进入污水站,进行有效的污水处理,达标后进入园区管网接口,(红线右侧外2米),进入园区污水处理厂。

图1-1 厂区平面图

请支付后下载全文,论文总字数:22380字

您需要先支付 80元 才能查看全部内容!立即支付

企业微信

Copyright © 2010-2022 毕业论文网 站点地图