登录

  • 登录
  • 忘记密码?点击找回

注册

  • 获取手机验证码 60
  • 注册

找回密码

  • 获取手机验证码60
  • 找回
毕业论文网 > 毕业论文 > 土木建筑类 > 建筑环境与能源应用工程 > 正文

太原人民医院病房楼空调设计毕业论文

 2020-04-15 08:04  

摘 要

本建筑是位于太原市的人民医院病房楼,建筑面积约30237m2,地下1层,地上10层。地下一层为地下车库和冷热源机房,地上一层为住院大厅、诊室等,二至九层为住院部,十层为办公室、报告厅等房间。需要对整个病房楼做空调系统的设计。

本次设计冷负荷计算采用冷负荷系数法的工程简化计算方法,空调系统方案确定为一层住院大厅、药房等房间采用全空气系统,二至九层病房和十层办公室等房间采用风机盘管加新风系统,水系统确定为冷冻水系统采用闭式、两管制、一次泵、异程式系统,冷却水系统采用开式、一级泵、变水量、异程式系统,热水系统采用闭式、一次泵、变水量系统,冷源采用两台30XW0902型水冷螺杆式冷水机组实现供冷,由于太原地处北方地区,热源采用城市热网接板式换热器通过水系统来实现供热。同时本次设计贯彻节能的理念,对风管系统单位风量耗功率和水系统的耗电输冷(热)比进行校核计算,设计内容均满足要求。

关键词:冷负荷 全空气系统 风机盘管加新风系统 冷热源 空调水系统

ABSTRACT

The building is located in the ward building of the People's Hospital of Taiyuan City, with a construction area of ​​about 30237 m2, a basement and 10 floors above ground. The basement floor is an underground garage and a cold and heat source room. The ground floor is a hospital hall, clinics, etc., the second to the ninth floor is the inpatient department, and the tenth floor is the office, the lecture hall and other rooms. The design of the air conditioning system is required for the entire ward building.

In this design, the cold load calculation used the engineering simplified calculation method of the cold load coefficient method. The air conditioning system scheme is determined to be the full air system for the first floor of the inpatient hall and pharmacy. The fan coil and fresh air system is used for the rooms of the second to ninth wards and the tenth floor offices, etc. The water system is determined to be a closed, two-control, primary pump, and different-program system for the chilled water system. The cooling water system use an open type, a primary pump, a variable water volume, a different-program system, and the hot water system is closed for the primary pump and variable water system .Two 30XW0902 water-cooled screw chillers are used for cooling. Since Taiyuan is located in the north, the heat source uses the urban heat network to connect the plate heat exchanger to achieve the heat supply through the water system. At the same time, this design implements the concept of energy saving, and calculates the unit air volume power consumption of the duct system and the power consumption cooling (heating) ratio of the water system, and the design content meets the requirements.

Keywords: cold load, full air system, fan coil and fresh air system, cold and heat source, air conditioning water system

目录

第一章 工程概况 1

1.1建筑概况 1

1.2建筑资料 1

1.3气象参数 1

1.3.1室外设计参数 1

1.3.2室内设计参数 1

1.3.3空调期设定 2

第二章 负荷计算 3

2.1.冷负荷计算说明 3

2.2冷负荷计算 3

2.2.1外墙、屋面传热形成的计算时刻冷负荷 4

2.2.2外窗只有内遮阳措施的辐射冷负荷 4

2.2.3外窗温差传热冷负荷 5

2.2.4相邻空间通风良好时内围护结构温差传热的冷负荷 6

2.2.5相邻空调房间有温差时的温差传热冷负荷 6

2.2.6人体散热形成的冷负荷及散湿量 6

2.2.7荧光灯散热形成的冷负荷 7

2.2.8设备显热形成的冷负荷 8

2.2.9总冷负荷汇总 8

2.3热负荷计算 9

2.3.1围护结构最小传热热阻计算 9

2.3.2围护结构传热耗热量Q1计算 9

2.3.3冷风渗透耗热量Q2 10

2.3.4外门冷风侵入量耗热量Q3 10

2.3.5围护结构的附加耗热量Q1-X 10

2.4负荷汇总 11

第三章 系统方案 12

3.1全空气系统 12

3.2风机盘管式系统 12

3.3系统划分要求 13

3.4系统方案确定 13

第四章 设备风冷量计算 15

4.1全空气系统风冷量计算 15

4.1.1全空气系统送风量计算 15

4.1.2全空气机组全冷量计算 16

4.2新风加风盘系统风冷量计算 16

4.2.1新风加风盘系统送风量计算 16

4.2.2新风量计算 17

4.2.3风机盘管风量计算 18

4.2.4新风加风盘系统排风量计算 18

4.2.5风机盘管冷量计算 18

4.2.6新风机组冷量计算 19

第五章 机组及风口的选择计算 20

5.1机组选择 20

5.1.1全空气处理机组 20

5.1.2风机盘管 20

5.1.3新风机组 20

5.1.4排风机 20

5.2风口选择 21

5.2.1送风口 21

5.2.2回(排)风口 21

第六章 系统气流组织校核计算 22

6.1全空气系统气流组织校核 22

6.1.1散流器送风参数 22

6.1.2散流器送风校核计算 22

6.2半集中式系统气流组织校核 23

6.2.1双层百叶侧送风参数 23

6.2.2双层百叶侧送风校核计算 23

第七章 空调风系统选择计算 25

7.1风管的选择 25

7.2风管的水力计算 25

7.3风管的不平衡率计算 28

7.4风管系统单位风量耗功率计算 28

第八章 空调水系统选择计算 30

8.1水管的选择 30

8.2水系统的形式 30

8.3冷冻水系统 31

8.3.1冷冻水系统水力计算 31

8.3.2冷冻水泵选型 35

8.4冷却水系统 35

8.4.1冷却水系统水力计算 35

8.4.2冷却水泵选型 35

8.5冷凝水系统 36

8.6热水系统 36

8.6.1热水系统水力计算 36

8.6.2热水水泵选型 36

8.7水管的不平衡率计算 36

8.8水系统的耗电输冷(热)比校核计算 37

第九章 冷热源设计 38

9.1冷热源方案选择 38

9.2制冷机房 38

9.3冷热源设备选型 39

9.3.1冷水机组 39

9.3.2板式换热器 39

9.3.3膨胀水箱 39

9.3.4分集水器 40

9.3.5冷却塔 42

第十章 通风设计 43

10.1通风方案确定 43

10.2通风系统水力计算 43

10.3风机选型 43

第十一章 空调系统管路的保温与防腐 44

11.1管路的保温 44

11.2管路的防腐 44

第十二章 空调系统的消声与减振 45

小结 45

参考文献 46

第一章 工程概况

1.1建筑概况

本工程为太原人民医院病房楼。地下一层为设备房和汽车库,层高4.5m,地上十层, 总建筑面积30237平方米。建筑高度为41.8米。地上1层为住院大厅、药房、计算机中心、医保办公室和超市,4.5m。2-9层为住部,3.6m,10层为档案馆、报告厅、图书馆和办公室等房间,4.0m。

本次设计为本建筑物的通风.空气调节及制冷换热机房设计。

1.2建筑资料

太原:寒冷A区 房间:轻型 低压系统

1.3气象参数

1.3.1室外设计参数

太原:东经:112°37′,北纬:37°47′;寒冷A区 房间类型:轻型低压系统;

夏季室外工况: t干=31.5℃ t湿=23.8℃

您需要先支付 80元 才能查看全部内容!立即支付

企业微信

Copyright © 2010-2022 毕业论文网 站点地图