登录

  • 登录
  • 忘记密码?点击找回

注册

  • 获取手机验证码 60
  • 注册

找回密码

  • 获取手机验证码60
  • 找回
毕业论文网 > 毕业论文 > 土木建筑类 > 给排水科学与工程 > 正文

庆鑫酒店建筑给排水设计毕业论文

 2021-11-11 08:11  

论文总字数:79991字

摘 要

本设计的主要任务是对武汉市一栋拟建的二十八层综合性酒店进行室内给水排水设计。该酒店总占地面积为3.0公顷,建筑面积25000平米左右,建筑高度96.500米。地下一层为设备用房。地上二十八层,一层为大堂,二至五层为办公,六层为设备转换层,七至二十八层为标准间,顶层有电梯机房。

建筑一至六层采用市政管网直接供水,七至二十八层分为三个区:七至十四层为低区、十五至二十一层为中区,二十二至二十八层为高区,采用并联式变频供水方式。

本建筑七至二十八层为酒店标准层,排水立管采用伸顶通气,设有通气立管。一至六层排水立管采用侧向通气,在地下室就近排出室外。

消火栓系统的设计应保证有2支水枪的充实水柱达到同层内任何部位。

自动喷水灭火系统采用湿式喷淋系统,共设置五个报警阀控制各区喷头。报警阀前管道设为环状,阀后管道为枝状,每一楼层均设置水流指示器、试水阀,每个湿式报警阀控制的最高一层需要设末端试水装置。

热水系统采用闭式热水供应系统,热水分区与生活给水系统相同,即低区为七至十四层,十五至二十一层为中区,二十二至二十八层为高区,各分区采用独立的换热设备供水。

关键词: 给排水设计;建筑给水系统;建筑排水系统;消火栓系统;自动喷水灭火系统;热水系统

Abstract

The main task of this design is to design the indoor water supply and drainage of a 28-story comprehensive hotel to be built in Wuhan. The hotel covers a total area of 3.0 hectares, with a construction area of about 25,000 square meters and a building height of 96.500 meters. The ground floor is the equipment room. On the 28th floor, the first floor is the lobby, the 2nd to 5th floors are offices, the 6th floor is the equipment conversion floor, the 7th to 28th floors are standard rooms, and the top floor has an elevator machine room.

The first to sixth floors of the building are directly supplied by the municipal pipe network. The seven to twenty-eight floors are divided into three areas: the seventh to fourteenth floors are low areas, the fifteenth to twenty-first floors are middle areas, and the twenty-two to twenty-eight The floor is high zone, adopting parallel frequency conversion water supply method.

The 7th to 28th floors of this building are the hotel's standard floors. The drainage risers are ventilated by roof extension and are equipped with ventilation risers. The first to sixth floor drainage risers are ventilated laterally and discharged outside the basement.

The design of the fire hydrant system should ensure that there are two water guns with a full water column reaching any part of the same floor.

The automatic sprinkler system uses a wet sprinkler system with a total of five alarm valves to control the sprinklers in each area. The pipeline in front of the alarm valve is set as a ring, and the pipeline behind the valve is branched. Each floor is provided with a water flow indicator and a water test valve. The highest level controlled by each wet alarm valve needs to be equipped with an end water test device.

The hot water system uses a closed hot water supply system. The hot water partition is the same as the domestic water supply system, that is, the low zone is from 7 to 14 floors, the 15 to 21 floor is from the middle zone, and the 22 to 28 floors are from In the high zone, each district uses independent heat exchange equipment for water supply.

Key Words:Water supply and drainage design; building water supply system; building drainage system; fire hydrant system; automatic sprinkler system; hot water system

目 录

第1章 绪论 1

1.1建筑地点及性质 1

1.2使用功能 1

1.3设计要求 1

1.4设计内容 1

1.5设计原始资料 1

1.5.1市政基础资料 1

1.5.2气象资料 2

第2章 设计说明书 3

2.1生活给水系统 3

2.1.1生活给水系统的供水方案 3

2.1.2生活给水系统的竖向分区 4

2.1.3主要设备及构筑物 4

2.1.4生活给水管道的布置与敷设 5

2.2热水给水系统 7

2.2.1 热水系统的供水方式 7

2.2.2热水系统的竖向分区 7

2.2.3主要设备 7

2.2.4热水给水的管道布置与管材 8

2.3建筑排水系统 9

2.3.1 排水系统的排水方案 9

2.3.2 排水系统的管道布置与敷设 9

2.3.3 泵房集水池 11

2.4消火栓系统 12

2.4.1 消火栓系统的技术参数 12

2.4.2地下室消防水池 12

2.4.3屋顶消防水箱 13

2.4.4消火栓箱 13

2.4.5水泵接合器 14

2.4.6消火栓管网 14

2.4.7消火栓加压泵 15

2.4.8增压稳压设备 15

2.5自动喷水灭火系统 16

2.5.1湿式报警阀 16

2.5.2水流指示器 16

2.5.3末端试水装置 17

2.5.4喷头选型与布置 17

2.5.5自动喷水灭火系统管网 17

2.5.6屋顶增压稳压设备 18

2.5.7自动喷水灭火系统加压泵 18

第3章 设计计算书 19

3.1 室内给水系统计算 19

3.1.1 最高日用水量计算 19

3.1.2地下室生活水箱 19

3.1.3管网水力计算 19

3.2 室内热水系统计算 30

3.2.1 基本参数计算 30

3.2.2热水配水管网计算 32

3.2.3热水配水管网热损失及循环流量计算 35

3.2.4计算循环管网的总水头损失: 52

3.2.5膨胀水罐 53

3.3 消火栓系统计算 55

3.3.1 消火栓水力计算 55

3.3.2消火栓加压泵扬程计算 57

3.3.3增压稳压设备计算 59

3.3.4消防水池 62

3.3.5屋顶消防水箱 63

3.4自动喷水灭火系统 65

3.4.1 管网水力计算 65

3.4.2喷淋加压泵扬程计算 68

3.4.3增压稳压设备的计算与选用 69

3.4.4气压水罐计算 70

3.5排水系统计算 73

3.5.1水力计算 73

3.5.2地下室集水池 75

致 谢 79

第1章 绪论

1.1建筑地点及性质

随着国家经济的快速发展和科学技术水平的不断提高,1980年代以后,中国的高层建筑迅速发展,城市的外观随着每一个经过日都发生了变化。1990年代以后,在高层建筑、更高规格、更完善的设备、更高技术要求的方向上开发了高层建筑,有从大城市到中小城市的倾向。高层建筑的种类主要有住宅建筑、酒店、营业所、事务所、综合大楼等。

该项目依赖于公共建筑和武汉地标建筑之一的武汉。项目是武汉建筑的代表性项目。因此,内部设备更加完善,对供水、排水的要求也越来越高。需要确保安全的供水、排水系统,以便人们在安全的环境中休息,嗯。

1.2使用功能

武汉市修建一栋28层的综合楼,总占地面积为3.0公顷,建筑面积25000平米左右,建筑高度96.500米。地下一层为设备用房。地上28层,一层为大堂,二至五层为办公,六层为设备转换层,七至二十八层为标准间,顶层有电梯机房。

1.3设计要求

通过修改建筑条件图,对中外文献进行咨询、调查、研究,并收集相关数据,绘制设计方案。致力于建筑、构造、暖气、换气、空调工程、建筑、电器等领域的调整。作为实际能力的审查。基于专业调整和区域实际情况,对选择合理设计方案进行了全面分析。

1.4设计内容

按照上级批准的设计任务书规定,新建一栋二十八层(地下一层)综合酒店。

要求设计室内给排水工程与土建工程配套,具体项目为:

(1)室内给水工程;

(2)室内排水工程;

(3)室内热水工程;

(4)室内消防工程。

1.5设计原始资料

1.5.1市政基础资料

该建筑物北侧道路下有市政给水管道,管径为DN400,常年可提供的资用水头为0.35MP,允许接管径为DN200,大楼40米范围无室外消火栓,污水管管径为DN600,管顶埋深为2.4米,雨水管管径为DN1200,管顶埋深为1.6米。

1.5.2气象资料

历年平均气温:16.72℃

最高:40.3℃

最低:-12.3℃

最大积雪深度:190mm

第2章 设计说明书

2.1生活给水系统

2.1.1生活给水系统的供水方案

(1)给水方式方案比选

本建筑市政给水管道常年可提供的资用水头为0.35MP。为充分利用市政管网压力。一至六层采用市政管网压力直接供给,七至二十八层采用加压泵加压供水,初步拟定以下两套方案:

方案一:泵箱供水方式

7至28层的全部用水量全部由地下室水泵提升至屋顶水箱,再分区供水,泵箱供水方式低区需设置减压阀。

水泵箱供水系统比较简单,水泵数量少,地下室面积小,初期投资少。水箱可以保证水箱的水量,因此水箱的供水更加安全可靠。但是,与频率变换供水模式相比,泵箱供水模式马达采用硬启动方式,容易引起水冲击,损坏管线和管线附件,影响卫生设备的使用。单位经常需要完全的加载操作来确保建筑物的供水。需要在屋顶上追加蓄水罐,另外,考虑到供水罐的设定,建筑物的抗负荷力大幅增加,对建筑物的结构物的耐力和抗震性没有贡献。二次污染的发生很容易。

方案二:变频水泵供水方式。

请支付后下载全文,论文总字数:79991字

您需要先支付 80元 才能查看全部内容!立即支付

企业微信

Copyright © 2010-2022 毕业论文网 站点地图