登录

  • 登录
  • 忘记密码?点击找回

注册

  • 获取手机验证码 60
  • 注册

找回密码

  • 获取手机验证码60
  • 找回
毕业论文网 > 毕业论文 > 土木建筑类 > 建筑环境与设备工程 > 正文

杭州通信枢纽工程辅楼通风空调工程设计毕业论文

 2022-06-16 09:06  

论文总字数:52552字

摘 要

杭州市通信枢纽工程分主楼与辅楼两个单体。本项目为辅楼,总建筑面积约为10200m2,地下一层,地上四层,建筑地面标高为23.50m。地下一层为自行车库及水泵房、锅炉房等设备用房。一至四层主要为餐厅、物业办公及健身中心等。要求对地下一层、地上一~四层进行通风空调设计;进行全楼空调用冷热源设计。通风空调设计面积约10200m2

本设计负荷计算采用非稳态方法计算冷负荷,计算出8:00~17:00的逐时冷负荷。三楼经理办公室采用风机盘管加独立新风系统,其他区域均采用全空气系统,新风处理到室内空气焓值,通入每个房间,不承担室内负荷。空调水系统总体采用异程形式水系统,采用异程形式的空气处理机组,设平衡阀与电动调节阀实现变水量运行,。本工程因地处杭州需夏季供冷冬季供热,夏季采用单螺杆式冷水机组进行制冷,选用两台型号为约克YSBABAS15CCE螺杆式冷水机组,冬季采用空调热源选用油气(天然气)两用真空热水锅炉两台,单台制热量为1.4MW,机房布置在地下1层,冷冻水温度为7/12℃,冷却水温度为32/37℃。

关键词:冷负荷 风机盘管 水力计算 冷热源

Design of HVAC System For A Communication hub auxiliary building of hangzhou

Abstract

Hangzhou city communications hub of the main building and auxiliary building two monomer. The total construction area of this project is 10200m2, the ground floor is four, and the floor elevation is 23.50m. Underground one for the garage and pump room, boiler room and other equipment room. One to four main dining room, property office and fitness center, etc.. The design of ventilation and air conditioning for one or four floors of the ground floor is required, and the cooling and heat source design of the whole air conditioning system is carried out.. Ventilation air conditioning design area of about 10200m2.

The design load is calculated by using the non steady state method to calculate the cooling load, and the hourly cooling load of 8:00 ~ 17:00 is calculated.. On the third floor of the office manager with fan coil plus fresh air systems and other areas are used all air system, fresh air to indoor air enthalpy value, access to each room, does not bear the load of the room. The air conditioning water system adopts the different way water system, and adopts the air - handling unit of different way, and the balance valve and the electric valve are used to achieve the variable water operation.,. This project located in Hangzhou need for summer cold winter heating, summer uses the single screw type water chiller refrigeration, use two types of York YSBABAS15CCE screw type water chiller in winter the use of air conditioning heat source selection of dual-purpose vacuum hot water boiler of oil and gas (natural gas) in two, the single heat of 1.4mw, room layout in the underground 1 layer, the temperature of cooling water was 7 / 12 DEG C, cooling water temperature is 32 / 37 degrees Celsius.

Key words:Cooling load, Fan Coil Unit(FCU),Hydraulic Calculation, Cold and heat sources

目录

摘要..................................................................................................................................................I

ABSTRACT...................................................................................................................................II

第1章 工程概况 1

1.1 工程名称 1

1.2 建筑概况 1

1.3 建筑气候分区 1

1.4建筑气候分区对建筑基本要求 2

1.5 设计参数 2

1.5.1 室外设计参数 2

1.5.2围护结构参数 3

1.5.3 人员密度、照明功率和电器设备功率 4

第2章 空调负荷计算 6

2.1 冷负荷构成和计算原理 6

2.1.1 冷负荷计算的规定 6

2.1.2 冷负荷计算方法 6

2.1.3 通过外墙和屋顶形成的逐时冷负荷 6

2.1.4 通过外窗形成的冷负荷 7

2.1.6人体、照明和设备等形成的冷负荷 8

2.1.7 一楼值班室诊室冷负荷汇总 10

第3章 空调方案的确定 12

3.1空调系统的选择 12

3.1.1空调系统的分类 12

3.1.2 各种空调系统适用条件和使用特点 12

3.1.3空调系统方案比较 13

3.2空调系统方案的确定 14

3.3空调水系统方案的选择及特点 14

3.3.1 冷冻水系统 15

3.3.2 冷凝水系统 16

3.3空调冷热源的选择 16

第4章 房间送分量、新风量及新风负荷的确定及末端设备的选择 18

4.1送风量的确定 18

4.1.1 全空气系统……………………………………………………………………...18

4.1.1风机盘管 新风系统夏季处理过程 20

4.1.2风机盘管 新风系统夏季室内计算过程 22

4.2新风量的确定 23

4.3 风机盘管冷量的确定 23

4.4 新风冷负荷 24

4.5 风机盘管的选型和安装方式 24

4.6 新风机组的选型 25

第5章 气流组织 28

5.1 常见送回风口形式 28

5.2 风机盘管侧送风气流组织计算 29

5.3 散流器下送风气流组织计算 33

第6章 空调风系统的设计 35

6.1 风管设计的基本内容 35

6.2 风管的分类 35

6.3 风管的设计要求 35

6.4 风管的水力计算 36

6.4.1风管水力计算方法 36

6.4.2风管水力计算步骤 36

6.4.3风管水力计算过程 37

第7章 空调水系统的设计 41

7.1 管材的选择和连接 41

7.2 管道试压 41

7.3 冷冻水供回水系统 41

7.3.1 冷冻水供回水系统选择 41

7.3.2 冷冻水供回水系统水力计算 41

7.4 冷凝水系统设计 46

7.4.1 冷凝水系统设计原则 46

7.4.2 冷凝水管径计算过程 46

第8章 制冷机房的设计与布置 48

8.1 制冷机房及其设备布置原则 48

8.2 设备选型 48

8.2.1 机组选择 48

8.2.2 冷冻水泵的计算与选择 48

8.2.3 冷却水泵的计算与选择 50

8.2.4 集水器和分水器 52

8.2.5 过滤器 53

8.2.6 膨胀水箱 54

8.2.7 电子水处理仪 55

8.2.8 阀门 55

8.2.9 冷却塔 56

第9章 通风设计 59

9.1 地上一至五层通风设计 59

第10章 管道的保温、防腐以及系统消声减震设计 60

10.1 保温设计 60

10.1.1 水管保温 61

10.1.2 风管保温 61

10.2 防腐设计 61

10.3 系统消声减震设计 62

10.3.1 消声 62

第11章 总结 64

参 考 文 献 65

第1章 工程概况

1.1 工程名称

杭州通信枢纽工程辅楼通风空调工程设计

请支付后下载全文,论文总字数:52552字

您需要先支付 80元 才能查看全部内容!立即支付

企业微信

Copyright © 2010-2022 毕业论文网 站点地图