登录

  • 登录
  • 忘记密码?点击找回

注册

  • 获取手机验证码 60
  • 注册

找回密码

  • 获取手机验证码60
  • 找回
毕业论文网 > 毕业论文 > 理工学类 > 建筑电气与智能化 > 正文

无锡市某街道服务用房办公楼电气设计毕业论文

 2022-01-26 11:01  

论文总字数:40813字

摘 要

毕业设计为无锡某街道服务用房办公楼的照明、动力及空调的供配电及控制系统设计、防雷与接地系统设计、火灾报警系统设计、综合布线系统设计。整个设计依据国家相关设计规范及标准与有关专业提供的设计资料。照明系统设计包括灯具型号、数量的选择和布置以及照明负荷计算、配电方式等。配电系统设计包括插座布置、动力设施的配电方式;选择电缆和桥架的型号、规格,控制和保护电器的型号、规格等。防雷接地系统根据相关要求进行设计。火灾报警系统包括火灾探测器、手动报警按钮、声光报警器等消防设备的布置与选型。综合布线系统涉及信息点和语音点的分布设置。

关键字: 照明系统 配电系统 防雷接地系统 火灾自动报警系统 综合布线系统

Electrical Design of a Street Service Building in Wuxi

Abstract

The graduation design is the lighting, power and air conditioning power supply and distribution and control system design, lightning protection and grounding system design, fire alarm system design and integrated wiring system design for a street service building in Wuxi. The entire design is based on relevant national design codes and standards and design materials provided by relevant professionals. Lighting system design includes luminaire model, quantity selection and layout, illuminance, lighting load calculation, and power distribution method. The distribution system design includes the socket layout, the power distribution mode of the power facility; the model, specification, control and protection type and specifications of the cable, bridge, busbar, etc. The lightning protection grounding system is designed according to relevant requirements. The fire alarm system includes the arrangement and selection of fire equipment such as fire detectors, manual alarm buttons, and sound and light alarms. The integrated wiring system involves the distribution of information points and speech points.

Keywords: lighting system; distribution system; lightning protection grounding system; fire alarm system; integrated wiring system

目录

摘要 I

Abstract II

第一章 系统概述 1

1.1工程概述 1

1.2设计概述 1

第二章 照明系统 2

2.1照明计算 2

2.1.1本工程照明器情况 2

2.1.2照明设计标准 2

2.1.3利用系数法 4

2.1.4照度计算 6

2.2照明负荷计算 18

2.2.1负荷计算的目的 18

2.2.2需要系数法确定计算负荷 18

第三章 配电系统 27

3.1按需要系数法确定计算负荷 27

3.2工程设计配电系统说明 32

3.3技术经济比较 33

第四章 防雷接地系统 34

4.1年雷击次数计算 34

4.2接地系统 34

第五章 火灾自动报警系统 35

5.1系统概述 35

5.2探测器的设置 35

5.2.1选择探测器 35

5.2.2确定数目及其布置 35

5.3系统及选型 36

第六章 综合布线系统 37

6.1系统概述 37

6.2设计方案 37

6.3子系统 37

参考文献 38

致谢 39

第一章 系统概述

1.1工程概述

此工程为无锡市的一处街道服务用房高层办公楼。共计12层,包括地下1层。办公楼的总高度为45m左右。本办公大楼属与二类建筑 。

1.2设计概述

设计对象是无锡市某街道服务用房办公楼。设计内容:

  1. 照明系统:首先根据照明设计标准选择照度及单位面积功率,再选择恰当的照明灯具;根据照度标准确定每个房间、公共场所的灯具数目及布置进行照明设计。对楼内各场所的单位功率密度进行检验。计算照明各回路的的电流值,选择恰当的整定值,确定断路器的类型。根据计算电流值,选择电线的截面积大小。线路的敷设方式在照明系统图进行标注。

二、配电系统:

1、本工程属二类建筑,消防用电负荷和普通客梯因为属于二级负荷,采用双电源供电 。

2、办公楼的低压系统设计选择树干式与放射式相结合的配电方式,配电干线全都采用低烟无卤阻燃型电线电缆,消防设备采用低烟无卤阻燃耐火型电力电缆沿电气竖井敷设。消防设备以及重要用电设备均采用低压双电源配电,并在其末端配电箱自动切换。

三、防雷接地系统:先计算年平均雷击次数,确定为三类防雷等级,再根据规范要求进行设计。屋顶设避雷网,利用结构主筋引下线。布置总等电位和局部联结箱以保证等电位。接地形式选用TN-S系统。本建筑接地共用办公楼地下基础接地体。强弱电井内的共用PE线利用两根40×4的热镀锌扁钢。

四、火灾自动报警系统:根据火灾发生的特点,选用感烟探测器为主。计算各场所的面积,探测器的保护面积和保护半径查询表格。根据公式计算一个探测区域的探测器数目。安装要求及其步骤参考规范,设计时应考虑到房间梁和房间隔离物的影响。

1、在出入口位置放手动报警按钮根据办公楼各层的实际情况,划分防火分区。每层线路都连至接线端子箱,接线端子箱前设置短路隔离器进行保护,这条线路上的设备总量不能超过32个。

请支付后下载全文,论文总字数:40813字

您需要先支付 80元 才能查看全部内容!立即支付

企业微信

Copyright © 2010-2022 毕业论文网 站点地图