登录

  • 登录
  • 忘记密码?点击找回

注册

  • 获取手机验证码 60
  • 注册

找回密码

  • 获取手机验证码60
  • 找回
毕业论文网 > 毕业论文 > 矿业类 > 采矿工程 > 正文

团山隧道开挖爆破设计毕业论文

 2021-07-01 12:07  

摘 要

本设计主要进行了东湖团山隧道暗挖部分的爆破设计。首先根据设计要求确定隧道断面形状、大小,然后再分析大、小团山的地质条件,对比开挖施工方案,确定不同等级围岩的最佳开挖方案。最后针对不同围岩的开挖方案,提出不同的爆破方案。在每一个爆破方案的设计中,通过查阅爆破标准以及参考以往类似爆破案例,确定不同等级围岩的炸药单耗,并计算出每个炮孔的炸药量和整个断面的炸药量。根据炮眼间距的选取,布置各类炮眼在断面的具体位置,结合计算数据整理出最终设计参数。根据炮孔位置设计出不同断面的爆破网络图,并选取合适的延期方案。在设计的最后,对易爆安全问题作出重要计算说明,完成整篇设计。

关键词:隧道爆破;光面爆破;毫秒延期爆破;短台阶开挖法;台阶分部开挖法

Abstract

This design mainly carries on the blasting design of the Subsurface Excavation part of the East Lake Tuanshan mountain tunnel.According to the design requirements to determine the shape of the tunnel section and size of the tunnel.And then analyze the geological conditions of the large and small Tuanshan mountain.Comparative excavation construction scheme,Determine the best excavation scheme of the different grades of surrounding rock.Finally, according to the different surrounding rock excavation scheme, different blasting schemes are designed.In every blasting scheme design, by referring to the standard blasting and reference previous similar blasting case determined for different grades of surrounding rock of explosive specific charge, and calculates the quantity of explosive for each hole of the explosive quantity and the whole section.According to the selected holespacing, arranging holes in the specific location of the section, combined with the calculation of sorting out the final design parameters.According to the position of blasting hole, the blasting network diagram of different sections is designed, and the appropriate delay scheme is selected.At the end of the design, it is important to calculate the safety of blasting to improve the whole design.

Key Words:Tunnel Blasting;Smooth Blasting;millisecond delay blasting;Short bench excavation method;step excavation method

目 录

第1章 绪论 1

1.1 设计背景 1

1.2 设计内容及要求 1

1.3 设计依据 1

1.4 设计原则 1

第2章 工程概况 3

2.1 工程简介 3

2.2 隧址区工程地质简介 4

2.2.1 场地位置 4

2.2.2 地形地貌 4

2.2.3 地质构造 5

2.3 爆区环境 5

2.4 工程要求 5

第3章 隧道开挖施工方案 7

3.1 隧道开挖总体施工方案 7

3.1.1 Ⅲ级围岩开挖施工 7

3.1.2 Ⅳ级围岩开挖施工 7

3.1.3 Ⅴ级围岩开挖施工 7

3.2 隧道开挖爆破施工方案 8

第4章 隧道开挖爆破设计 9

4.1 设计原则 9

4.2 短台阶开挖法爆破设计 9

4.2.1 台阶爆破参数设计 9

4.2.2 装药结构及堵塞方式设计 14

4.2.3 爆破网路设计 14

4.3 台阶分部开挖法爆破设计 16

4.3.1 爆破参数设计 17

4.3.2 装药结构及堵塞方式设计 18

4.3.3 爆破网路设计 18

4.3.4 Ⅴ级围岩施工方法 18

4.4 爆破效果监测及爆破设计优化 18

4.4.1 爆破效果检查 18

4.4.2 爆破设计优化 18

第5章 爆破安全及预防措施 20

5.1 爆破振动及控制措施 20

5.1.1 受爆破地震影响的建筑(构)物和爆破震动控制标准 20

5.1.2 安全允许最大单段用药量计算 20

5.1.3 降低和控制爆破振动的措施 21

5.2 关于爆破振动测试 21

5.3 关于敏感建筑物的爆前鉴定 21

5.4 爆破有毒有害气体控制措施 22

5.4.1 一般规定 22

5.4.2 通风方案 22

5.5 感应电引起的早爆和预防 22

第6章 安全保证措施 23

第7章 爆破施工操作技术要求 24

7.1 爆破作业程序 24

7.2 炮孔布置与凿岩 24

7.3 装药操作 24

7.4 警戒与起爆作业 24

7.5 爆后检查与警戒解除 25

参考文献 26

附 录 27

致 谢  28

第1章 绪论

1.1 设计背景

武汉东湖景区是武汉市内为数不多的4A级风景区,而围绕东湖景区的环湖车道作为一条交通干道,暴露出来的交通堵塞问题非常严重,景区的生态环境也因此遭到了严重的破坏。为解决这个问题,国家和武汉市政府提出修建东湖通道方案。东湖风景区内的大小团山地处于本次设计之内,为最大程度保护山体,避免劈山开路,于是决定修建团山隧道。依据围岩等级等地质条件,在隧道开挖的部分地段采用爆破法施工,隧进行团山隧道爆破施工设计。

1.2 设计内容及要求

您需要先支付 80元 才能查看全部内容!立即支付

企业微信

Copyright © 2010-2022 毕业论文网 站点地图