登录

  • 登录
  • 忘记密码?点击找回

注册

  • 获取手机验证码 60
  • 注册

找回密码

  • 获取手机验证码60
  • 找回
毕业论文网 > 毕业论文 > 环境科学与工程类 > 环境科学 > 正文

硝酸改性天然锰氧化物去除双酚A机理研究毕业论文

 2022-01-14 09:01  

论文总字数:15448字

摘 要

本文利用天然锰矿石去除双酚A废水,分别探究反应体系pH、双酚A初始浓度、硝酸改性锰矿石投加量3种影响因素对双酚A去除率的影响。根据实验结果发现,伴随反应的体系的pH值上升,双酚A的降解效果出现明显衰弱。当反应pH=3时,反应6小时后,双酚A的去除率达到92.9%其他pH 情况下,双酚A去除率均小于90%;当硝酸改性锰矿石的投加量为1-5g/L,双酚A初始浓度为10mg/L时,双酚A去除率在反应6h后全都达到了90% 。因此,硝酸改性锰矿石投加量越多及双酚A初始浓度在10mg/L和25mg/L之间时,去除效果就越好。最后对3种影响因素进行综合分析,得到了最优的反应条件即反应体系pH=3,硝酸改性锰矿石投加量为1g/L,双酚A初始浓度为10mg/L时双酚A的降解效果最佳。通过对3种影响因子与双酚A去除率之间进行动力学方程拟合发现,三者都符合一级动力学方程,并且拟合度都超过0.9。

关键词:双酚A 锰矿石 动力学

Degradation Mechanism of BispHenol A with Modified Natural Manganese Ore by Nitric Acid

Abstract

In this paper, natural manganese ore was used to remove bispHenol A wastewater, and the effects of three factors including the pH of the reaction system, the initial concentration and the dosage of nitric acid-modified natural manganese ore on the removal rate of reactive blue were investigated. The experimental results show that the removal rate of bispHenol A decreases significantly with the increase of pH value of the reaction system[1]. When the reaction pH=3, the removal rate of bispHenol A reached 92.9% after 6 hours of reaction; when the dosage of nitric acid-modified natural manganese ore was 1g/L and above, and the initial concentration of bispHenol A was 10mg/L. At the time, the bispHenol A removal rate reached 90% after 6 hours of reaction. Therefore, the more the nitric acid-modified natural manganese ore is added and the initial concentration of bispHenol A is between 10 mg/L and 25 mg/L, the better the removal effect. Finally, a comprehensive analysis of the three influencing factors, the optimal reaction conditions were obtained, ie, the reaction system pH=3, the dosage of nitric acid modified Tiangan ore was 1g/L, and the initial concentration of bispHenol A was 10mg/L. The degradation effect is better. By kinetic equation fitting between the three influencing factors and the removal rate of bispHenol A, all three were in accordance with the first-order kinetic equation, and the fitting degree exceeded 0.9.

Keywords: Methyl orange; Manganese oxide ; Kineyi.

目录

摘要 I

Abstract II

第一章 绪论 1

1.1研究背景 1

1.1.1环境内分泌干扰物的概念 1

1.1.2双酚A的性质 1

1.1.3双酚A的来源 1

1.1.4双酚A的危害和生态影响 2

1.2锰氧化物的概述 2

1.2.1锰氧化物的性质 2

1.2.2锰氧化物对有机物的降解研究 3

1.3双酚A的降解技术 3

1.3.1生物降解法 3

1.3.2吸附法 3

1.3.3光降解法 4

1.3.4电化学氧化法 4

1.3.5臭氧氧化法 4

1.3.6高级氧化法 4

1.3.7膜分离技术 4

1.3.8反渗透法 5

1.3.9膜生物反应器法 5

1.4研究的目的及主要内容 5

1.4.1研究的目的 5

1.4.2研究的内容 6

第二章 实验材料及内容 7

2.1实验材料和仪器 7

2.2材料及溶液的配制 8

2.3溶液浓度测定方法 8

2.4实验步骤 9

2.4.1震荡时间和硝酸浓度的影响 9

2.4.2 pH的影响 9

2.4.3投加量的影响 10

2.4.4双酚A初始浓度的影响 10

2.4.5双酚A降解的空白实验 11

第三章 实验结果与讨论 12

3.1不同震荡震荡时间和硝酸浓度的影响 12

3.2不同pH的影响 13

3.3不同锰矿石投加量的影响 14

3.4不同双酚A初试浓度的影响 15

3.5双酚A的降解的空白实验 16

3.6 去除率的动力学分析 17

3.6.1动力学简介 17

3.6.2动力学结果 17

3.7 反应溶液中Mn2 含量的测量分析 21

第四章 结论与展望 22

参考文献 23

致谢 26

第一章 绪论

1.1研究背景

1.1.1环境内分泌干扰物的概念

环境内分泌干扰物是指会对健康个体产生危害或对健康个体后代产生内分泌功能有害影响的一种外源性物质[2]。环境内分泌干扰物具有类似生物体内分泌激素的功能,进入生物体内后悔干扰正常的激素分泌、反应等。环境激素具有许多特点,如分布广泛、种类繁多、易被生物富集、难降解等。

1.1.2双酚A的性质

双酚A,学名2,2-双(4-羟基苯基)丙烷。白色晶体,熔点156〜158℃。它主要用于制备环氧树脂(约65%)和聚碳酸酯(约35%)[3]。

双酚A是重要的有机化工原料,双酚A的钾盐钠盐是制作聚枫的原材料[4]。苯酚和丙酮的重要衍生物,主要用于生产聚碳酸酯,环氧树脂,聚砜树脂,聚苯醚树脂和其它聚合物材料[5]。也可使用在增塑剂,阻燃剂,抗氧剂,热稳定剂,橡胶防老剂,农药,涂料等精细化工产品中[6]。

请支付后下载全文,论文总字数:15448字

您需要先支付 80元 才能查看全部内容!立即支付

企业微信

Copyright © 2010-2022 毕业论文网 站点地图